The Badass CS adapter allows the mounting of the pin-shaped sensors, which are used e.g. for Flyer with Panasonic motors or Bulls with Brose motors, so that the badassBox can be used.
Installation
The pin-shaped CS sensor is located in the area of the dropout.
To get to the sensor you have to remove the rear wheel.
Unscrew the screws of the bracket that secures the sensor to the dropout.
Separate the sensor from the bracket.
Insert the pin-shaped sensor into the adapter so that the flat side of the sensor is aligned with the corresponding recess in the adapter. The sensor must be inserted completely into the adapter, so that only the cable protrudes and the snap closes flush with the surface of the adapter. (In the photo, the sensor is not yet completely inserted).
Attach the adapter to the frame of your bike with the supplied cable ties.
Reinstall the rear wheel.
Slide the badassBox onto the adapter until it clicks into place.
Mount the spoke magnet and align it with the edge of the badassBox housing. That's it. Have fun with your faster e-bike!
